Water Butt Linking Kit

Water Butt Linking Kit

The water butt linking kit allows you to daisy chain your water butts together and thus collect even more rain water from your outside downpipes.

Fitting Instructions for Water Butt Linking Kit

Ensure that the two water butts are on a level surface and no more than 39cm apart.

You can connect the water butts either at the top or at the bottom.

If connected at the bottom the 2 water butts will fill at the same rate.

If connected at the top the first water butt will fill then run over into the second.

1. Drill a 25mm hole approx. 25cms from the top or the bottom into opposite sides of the water butts to be connected. Before drilling make sure both butts are facing forwards with the taps at the front.

WARNING: If there is already water in the water butts do not use an electric drill.

2. Fit the washer to the connector and screw tight into the water butt using the backing nut on the inside.

3. Join the water butts together with the supplied hose.